Brand 
 Foshan Heiner 
 Model 
 HN-60/90/120 
 Material 
 PVC sheet 





 GB/T10587-2006 technical conditions salt spray test chamber 
 This standard applies to electrical, electronics and other products, parts and materials for salt spray test chamber. 
 First, the salt spray chamber conditions of use 
 1.1 Environmental Conditions 
 a) Temperature: 15 ℃ ~ 35 ℃; 
 b) Relative humidity: not more than 85%; 
 c) Atmospheric pressure: 80kPa ~ 106kPa; 
 d) no strong vibration around; 
 e) No direct sunlight or other cold, heat, direct radiation; 
 f) no strong airflow around, should be compulsory when the ambient air flow, air flow should not be blown directly on the box; 
 g) no strong electromagnetic fields surrounding influence; 
 h) around the high concentration of dust and non-corrosive material. 
 1.2 Power conditions 
 a) Voltage: 220V ± 22V, 380V ± 38V; 
 b) Frequency: 50Hz ± 0.5Hz. 
 1.3 Test load 
 Chamber of the load should also meet the following conditions: 
 a) the total mass of the load volume in the studio per cubic meter placed no more than 80kg; 
 b) The total volume of the load capacity of not more than Studio 1 / 5; 
 c) the load must not touch each other, the interval should not affect the salt spray from the free fall in the test load, and saline solution dripping from a load to other load. 
 Second, the salt spray test chamber performance 
 2.1 Performance requirements 
 2.1.1 test temperature and allowed deviation: 35 ℃ ± 2 ℃. 
 2.1.2 The temperature fluctuation is no more than 1 ℃. 
 2.1.3 The temperature gradient is not greater than 2 ℃. 
 2.1.4 Salt spray deposition rate of indoor work (1.0 ~ 2.0) mL / (h * 80cm 2). 
 2.2 The product structure and appearance requirements 
 2.2.1 Test the salt spray chamber and the salt solution should not be direct contact with the material and the salt solution and salt spray from a chemical reaction, not direct contact with the parts should be resistant to salt corrosion. 
 2.2.2 Salt spray test should not be directly sprayed onto the sample. 
 2.2.3 the inner walls of the box at the top and condensate, and other parts of the test sample should not be dripping. 
 2.2.4 Box and external pressure must be balanced vent pressure balance should be set. 
 2.2.5 There should be placed on the samples holder. Sample frame should not